Vestnik of Samara State Technical University. Technical Sciences SeriesVestnik of Samara State Technical University. Technical Sciences Series1991-85422712-8938Samara State Technical University16870110.14498/tech.2022.4.7Research ArticleDesigning of traction motor stators coreZubkovYuri V.<p>Dr. Sci. (Techn.), Professor</p>zub577@mail.ruVereshaginVladislav E.<p>Postgraduate Student</p>zub577@mail.ruSamara State Technical University010220233041021143101202331012023Copyright © 2023, Samara State Technical University2023<p>Electric drive is widely used in automotive practice. Its basis is an electric traction motor (TM), which, compared with an internal combustion engine (ICE), has such advantages as high efficiency, high overload capacity, a wide range of speed control, and the possibility of torque direct transmission to the drive wheels. The main requirements for a traction motor are high efficiency over the entire load range, ease of speed and torque control, high overload capacity, small weight and dimensions, regenerative braking capability, wide speed control range, simplicity and ease of maintenance. The most widely used as traction motors are synchronous electric machines with excitation from permanent magnets (PM). They are characterized by high torque density, efficiency and power consistency over a wide speed range. However, there are a number of problems that hinder the introduction of these electric machines in the traction drive of home cars, one of which is the lack of a methodology for choosing the design of an armature and an inductor at the stage of calculating the main dimensions of an TM with magnetoelectric excitation, taking into account the variety of schemes and methods of winding, PM placement in the inductor. The article deals with the issues of choosing electromagnetic loads for various cooling methods, the size of the non-magnetic gap, an algorithm for electromagnetic calculation based on the maximum torque, containing a number of refining cycles, is proposed. The values of inductances and design factors are determined by numerical simulation of the magnetic field. The features of the design and circuit design of the core and armature winding are considered. Distribution curves of magnetomotive forces of distributed and concentrated windings are obtained, their harmonic analysis is made, recommendations are given on the configuration of the TD armature active zone.</p>traction motorpermanent magnetsdesignarmature windingтяговый двигательпостоянные магнитыпроектированиеобмотка якоря[Jose C.P., Meikandasivam S.A. Review on the Trends and Developments in Hybrid Electric Vehicles // In Innovative Design and Development Practices in Aerospace and Automotive Engineering. Singapore. 2017. Pp. 211–229.][Boldea I., Nasar S.A. Electric drives // Boca Raton: CRC Press, 1999. 411 p.][Anuchin A.S., Alyamkin D.I., Kozachenko V.F., Lashkevich M.M., Ostrirov V.N. Directions for the development and optimization of electric drive systems for urban hybrid and electric transport // Elektrotechnica. Znak. 2015. No. 1. Pp. 5–9.][Sleptsov M.A. Osnovy elektricheskogo transporta [Fundamentals of electric transport]. М.: Academiya, 2006. 465 pp.][Wang Y., Bianchi N., Bolognani S., Alberti L. Synchronous Motors for Traction Applications // 2017 Int. Conf. of Electrical and Electronic Technologies for Automotive. DOI: 10.23919/EETA.2017.7993210.][Makarichev Yu.A., Zubkov Yu.V., Vereshagin V.E., Vladimirov D.A. Magnetoelectric motor-generator of an autonomous mobile object // Elektroenergiya. Peredacha i raspredelenie. No. 3(66). 2021. Pp. 118–127.][Patil M.S., Dhamal S.S., Wagh K.K. A Detailed Motor Selection for Electric Vehicle Traction System // Proc. of the Third Int. Conf. on I-SMAC. 2019. Pp. 679–684.][Makarichev Yu.A., Zubkov Yu.V., Ivannikov Yu.N., Gulyaev I.V. Analysis of the Characteristics of an Electromechanical Starter in a Gas Turbine Plant // Russian Electrical Engineering. 2019. No. 7. Pp. 24–32.][Bukšnaitis J. Estimation of Winding Factors of Two-layer Three-phase Fractional Windings // Elektronika and Elektrotechnika. 2009. No. 8(96). Pp. 23–26.][Gerve G.K. Obmotki elektricheskih mashin [Windings of electrical machines]. Leningrad: Energoatomizdat, 1989. 400 p.][Bespalov V.Ya., Kovarskiy M.E., Sidorov A.O. Investigation of electromagnetic torque pulsations of synchronous machines with permanent magnets with integer and fractional q values // Elektrichestvo. 2018. No. 5. Pp. 45–52.][Zaharenko A.B. Sozdanie visokomomentnyh elektricheskih mashin s postoyannymy magnitami: Diss. … dokt. tech. nauk. Moscow, MEI, 2008. 42 p.][Zubkov Yu.V., Kaurov S.Yu., Vereshagin V.E. Study of the operation of an integrated starter-generator when starting an internal combustion engine // Vestn. Samar. Gos. Tekhn. Un-ta. Ser. Tekhn. Nauki. 2020. No. 3(67). Pp. 125–138.][Anuchin A.S. Razrabotka tsifrovyh sistem effektivnogo upravleniya komplektov tyagovogo elektrooborudovaniya gibridnyh elektricheskih transportnyh sredstv: Diss. … dokt. tech. nauk. Moscow, MEI, 2018. 445 p.][Berbirenkov I.A., Lohnin V.V. Traction motors with permanent magnets in the electric drive of a car // Elek. i inform. kompl. i sist. 2011. Vol. 7, No. 2. Pp. 10–12.][Gerada D., Xu Z., Huang Xu, Gerada Ch. Fully-integrated high-speed IM for improving high-power marine engines // IET Electric Power Applications. 2019. V. 13, Iss. 2. Pp. 148–153.]