Experimental study of the effect induced by air shot-blasting processing, thermal exposition and high cycle fatigue tests on physical and mechanical condition hardening layer of cylindrical samples of alloys V95 and D16T
- Authors: Radchenko V.P1, Morozov A.P1
-
Affiliations:
- Samara State Technical University
- Issue: Vol 14, No 2 (2010)
- Pages: 222-228
- Section: Articles
- Submitted: 18.02.2020
- Published: 15.06.2010
- URL: https://journals.eco-vector.com/1991-8615/article/view/21072
- ID: 21072
Cite item
Full Text
Abstract
The influence of multicycle fatigue actions and thermal exposition, previously hardened in the rate of the air shot-blasting, on such characteristics of cylindrical samples made from alloys V95 and D16T as roughness and microhardness was researched. In fact, surface plastic hardening significantly affects the growth of microhardness in comparison with samples unhardened. Microhardness decreases to values corresponding to sample unhardened after thermal exposition. Surface hardening increases the roughness layer and further thermal exposition and fatigue tests have no effect on these parameters. Results of experimental measurements are presented in tables and graphs.
About the authors
Vladimir P Radchenko
Samara State Technical University
Email: radch@samgtu.ru
(д.ф.-м.н., проф.), зав. кафедрой, каф. прикладной математики и информатики; Самарский государственный технический университет; Samara State Technical University
Andrey P Morozov
Samara State Technical University
Email: andrel5@inbox.ru
студент, каф. прикладной математики и информатики; Самарский государственный технический университет; Samara State Technical University
References
- Сулима А. М., Шулов В. А., Ягодкин Ю.Д. Поверхностный слой и эксплуатационные свойства деталей машин. - М.: Машиностроение, 1988. - 240 с.
- Сулима А. М., Евстигнеев М. И. Качество поверхностного слоя и усталостная прочность деталей из жаропрочных и титановых сплавов. - М.: Машиностроение, 1974. - 250 с.
- Биргер И. А. Остаточные напряжения. - М.: Машгиз, 1963. - 232 с.
- Кирпичёв В. А., Букатый А. С. Влияние режимов пневмодробеструйной обработки на остаточные напряжения, микротвёрдость и сопротивление усталости / В сб.: Физика прочности и пластичности материалов: Труды XVII Междунар. конф. - Самара: СамГТУ, 2009. - Т. 1. - С. 109-111.
- Радченко В. П., Морозов А. П., Букатый А. С. Влияние многоцикловых усталостных испытаний на физико-механическое состояние упрочнённого слоя плоских образцов // Вестн. Сам. гос. техн. ун-та. Сер. Техн. науки, 2009. - №3(25). - С. 158-165.