Earlier, it was established that maximum mineralization of the contact layer of snow occurs in spring at the interface with substrates (soil or ice). This study analyzes the temperature and moisture conditions during this period at the interface of the contact layer of snow with substrates by examining frozen sand blocks saturated with a solution containing complex gold ions, or blocks filled with polystyrene containing ions of molybdenum, copper, etc. It is assumed that the migration of ions from the underlying substrate into the contact layer of snow cover in spring occurs along quasi-liquid films on the surface of snow crystals, the thickness of which exceeds the equilibrium one. Migration becomes noticeable when the temperature at the snow–substrate contact reaches −13 °С and above. The appearance of quasi-liquid films on the surface of snow particles under variable temperature and moisture conditions is possible due to the condensation of water vapor, which during the day, with general heating of the system, can enter the contact layer of snow both from above and below. With an increase in snow density in the spring, the mineralization of the near-contact layer of snow cover increases. At the same time, linear relationships were revealed between the content of substrate components migrating into the near-contact layer of snow and the gradient of water vapor density in it. The reliability of the approximation of these dependencies for the gold thiosulfate complex is 0.98; for copper ions – 0.52; for hydrogen ions – 0.88; for sodium ions – 0.69, for chloride anions – 0.89. The results of the study substantiate the increased efficiency of geochemical prospecting for mineral deposits using snow cover in the spring.