Analysis of Mechanics of the Process of Cutting Hardened Material. Chip formation
- 作者: Olenin LD1
-
隶属关系:
- MSTU MAMI
- 期: 卷 2, 编号 1 (2008)
- 页面: 183-190
- 栏目: Articles
- URL: https://journals.eco-vector.com/2074-0530/article/view/69708
- DOI: https://doi.org/10.17816/2074-0530-69708
- ID: 69708
如何引用文章
全文:
详细
The works states results of the chip formation mechanics analysis, which considered as a combination of two continuously going actions: chip formation and plastic forming of a subsurface layer; the deformed material is considered as a mechanical system with several degrees of freedom. Proposed is a common velocity vector diagram for chip formation with forming of a subsurface layer, obtained are physical equations for the forecast of chip escape velocity and deformation, pressure and force on tool surface with angled major cutting edge.
参考
- Развитие науки о резании металлов. Колл. авт. под ред. Н.Н. Зорева. - М.: Машиностроение, 1967.
- Грановский Г.И., Грановский Б.Г. Резание металлов. М.: Высшая школа, 1995.
- Оленин Л.Д. К анализу механики стружкообразования. В сб. Избранные труды МНТК ААИ 39 «Приоритеты развития отечественного автостроения и подготовка инженерных кадров». Электронное изд. на CD, 2003.
- Чудаков П.Д., Коробкин В.Д. Определение мощности пластической деформации на поверхности разрыва скоростей в упрочняющемся материале // Разработка и исследование технологических процессов обработки металлов давлением. М.: Машиностроение. 1968. с. 34…42.
补充文件
