Email this article Design and simulation of microwave filter with flip-chip contacts
- Authors: Skovorodnikov S.1, Semenov D.1
-
Affiliations:
- ООО «СДС Электроникс»
- Issue: No 4 (235) (2024)
- Pages: 72-74
- Section: Microwave electronics
- URL: https://journals.eco-vector.com/1992-4178/article/view/633155
- DOI: https://doi.org/10.22184/1992-4178.2024.235.4.72.74
- ID: 633155
Cite item
Open Access
Access granted
Abstract
The article presents the results of simulating microwave bandpass filter using the domestic Gamma CAD system and comparing them with parameters measured on production samples. The possibility of estimating the dielectric constant of materials used for the manufacture of microwave filters has been studied.
Full Text
About the authors
S. Skovorodnikov
ООО «СДС Электроникс»
Author for correspondence.
Email: SkovorodnikovS@sds-e.net
технический директор
Russian FederationD. Semenov
ООО «СДС Электроникс»
Email: Semenov@sds-e.net
стратегический директор
Russian FederationReferences
- Бахарев С.И., Вольман В.И., Либ Ю.Н. Справочник по расчету и конструированию СВЧ полосковых устройств, 1982.
- https://www.sevsu.ru/innovation/sapr-gamma/.
Supplementary files
Supplementary Files
Action
1.
JATS XML
2.
Fig. 1. Band-pass filter with flip-chip contacts with a debug board
Download (82KB)
3.
Fig. 2. Group blank with filters with flip-chip type contacts
Download (130KB)
4.
Fig. 3. Typical AFC of a band-pass X-band filter with flip-chip contacts (operating bandwidth 20% relative to the center frequency)
Download (63KB)
5.
Fig. 4. Frequency response of a band-pass filter with flip-chip contacts calculated in CAD Gamma and measured on a serial sample
Download (345KB)
6.
Fig. 5. Electromagnetic field distribution of a band-pass filter with flip-chip contacts calculated in CAD Gamma
Download (113KB)
7.
Fig. 6. AFC of X-band band-pass filter with flip-chip contacts and its calculated value in CAD "Gamma" with substrate dielectric constant 0.7 different from the nominal value
Download (327KB)
