Email this article Technology of Threading of High-length Threads
- Authors: Timiryazev VA1, Khostikoev MZ2, Chertov FN1
-
Affiliations:
- MGTU STANKIN
- Gubkin RSU of Oil and Gas
- Issue: Vol 5, No 2 (2011)
- Pages: 177-180
- Section: Articles
- URL: https://journals.eco-vector.com/2074-0530/article/view/69953
- DOI: https://doi.org/10.17816/2074-0530-69953
- ID: 69953
Cite item
Full Text
Abstract
The work describes the process of threading of high-length threads using tangential heads, in which the length is not limited by the width of thread part of rollers, unlike normal thread rolling. It is achieved by different geometry of rollers, special positioning of them in relation to a part, and combination of feed rates in different directions.
Keywords
About the authors
V A Timiryazev
MGTU STANKINд.т.н. проф8 905 573 09 95; МГТУ «СТАНКИН»; MGTU STANKIN
M Z Khostikoev
Gubkin RSU of Oil and Gasк.т.н. доц8 985 923 50 15; РГУ нефти и газа им. И.М. Губкина; Gubkin RSU of Oil and Gas
F N Chertov
MGTU STANKINMGTU STANKIN
References
- Хостикоев М.З. Управление геометрией инструмента в процессе обработки. Ж. Горный информационно-аналитический бюллетень. Москва, 2011 г., № 4, с. 319-321.
- Хостикоев М.З., Темников В.А., Телегина О.А. Технология накатывания винтовых поверхностей на валах. Сборник научных трудов семинара «Современные технологии в горном машиностроении», М., МГГУ, 2011, с.80-83.
Supplementary files
