The quality of plunge-feed grinding process control under the use of piecewise algorithms.


The questions of control of technical processes of plunge-feed grinding under the restrictions
on phase coordinates by quality factors are considered. The frontier of piecewise control is
analyzed. The loss of efficiency under the use of such algorithms is estimated

About the authors

Vladimir G Shchetinin

Samara State Technical University

(к.т.н., доц.), доцент каф. автоматики и управления в технических системах; Самарский государственный технический университет; Samara State Technical University


  1. Михелькевич В.Н. Автоматическое управление шлифованием. - М.: Машиностроение, 1975. - 304 с.
  2. Медведев А.С. Структурное моделирование и синтез системы автоматического управления процессом шлифования на координатно-шлифовальном станке: дисс. … канд. техн. наук. - Самара, 2009. - 206 с.



Abstract: 43

PDF (Russian): 24


Article Metrics

Metrics Loading ...



  • There are currently no refbacks.

Copyright (c) 2012 Samara State Technical University

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies