No 11 (2012)

Articles

State and trends of development of the tractor industry for Russian forest complex

Bartenev I.M., Drapalyuk M.V.

Abstract

Problems and trends of development of domestic tractor industry supplying the forest complex are considered.
Tractors and Agricultural Machinery. 2012;(11):3-7
pages 3-7 views

Designing conception of innovative development and modernization of integrated mechanization of agro-industrial complex for the period up to 2025

Beylis V.M., Antyshev N.M.

Abstract

Trends of development of integrated mechanization of the agro-industrial complex on the period up to 2025 as well as basic provisions of the conception are stated. The key role of the system of technologies and machinery in provision of rural commercial producers with required high-performance technologies and machinery is identified.
Tractors and Agricultural Machinery. 2012;(11):7-10
pages 7-10 views

Problems of Russia’s membership in the WTO

- -.

Abstract

На очередном заседании «Меркурий-клуба», посвященном проблемам и перспективам работы российского бизнеса в условиях членства Российской Федерации во Всемирной торговой организации, особое внимание было уделено защите российского рынка, выгодам и перспективам для российского бизнеса на мировом и внутреннем рынках, подготовке специалистов для работы в новых экономических условиях.
Tractors and Agricultural Machinery. 2012;(11):10
pages 10 views

A fire-resistant environmentally friendly fluid for hydrostatic transmissions

Godzhayev Z.A., Shabalinskaya L.A., Zaytsev S.D.

Abstract

Results of investigation of a fire-resistant water-containing fluid for hydrostatic power drive of mobile machines on the unique «Climate» test bench are given.
Tractors and Agricultural Machinery. 2012;(11):10-13
pages 10-13 views

Recording system for the investigation of slipping and efficiency coefficient of differential gear and wheeled mover

Gorshkov Y.G., Chetyrkin Y.B., Kalugin A.A.

Abstract

A research technique of slipping and efficiency coefficient of differential gear and wheeled movers used in agriculture is given. A construction of recording system is proposed.
Tractors and Agricultural Machinery. 2012;(11):13-15
pages 13-15 views

On a method of development of control programs for gear shifting without breaking of power flux

Lysov A.M.

Abstract

One of possible methods of development of gear shift control programs for the trip computers of agricultural tractors equipped with transmissions with gear shift under load, intended for the security of smooth shifting under different operation modes is proposed.
Tractors and Agricultural Machinery. 2012;(11):16-21
pages 16-21 views

Features of designing of a wheel small-sized skidding tractor

Voynash S.A., Voynash A.S.

Abstract

It is proposed to mechanize the operation of timber harvesting in peasant (farm) enterprises in forest-steppe areas of Altai territory and other regions of Russian Federation by the way of using a small-sized skidding tractor. Construction of the tractor is substantiated.
Tractors and Agricultural Machinery. 2012;(11):21-23
pages 21-23 views

Rise of adequacy of analytical models with a random frequency to Gaussian processes

Soloveychik A.A.

Abstract

Methods of analytical modeling of a stochastic process for investigation of non-linear dynamic systems under Gaussian effects are stated. As a test example the determination of dispersion of angular velocity of engine shaft of agricultural aggregate is used. Non-linearity of its regulating system parameters is considerable.
Tractors and Agricultural Machinery. 2012;(11):24-28
pages 24-28 views

Classification of mechanization means of tools for seeds plowing down

Yemelyanov P.A., Aksionov A.G., Sibiriov A.V.

Abstract

Results of patent and technical analysis of current tools for seeds plowing down of seeders and planters are given. Their basic highs and lows are reflected. Classification of plowing tools for onion seeders is compiled, trends of their development are projected.
Tractors and Agricultural Machinery. 2012;(11):28-30
pages 28-30 views

Mathematical modeling of grain harvesting combines fleet in a farm

Pyanov V.S.

Abstract

A mathematical model of estimation of technical and economical characteristics of work of combine fleet in a farm is stated. Efficiency of large-scale farms and using of high-performance combines are revealed as well as conditions of their optimal using. A nomogram for the calculation of different characteristics of combine fleet in a farm is given.
Tractors and Agricultural Machinery. 2012;(11):30-33
pages 30-33 views

Algorithm of plotting of the developable working surfaces of ploughs

Vaskov A.A.

Abstract

Conceptions and methods of plotting of the developable ploughshare and loading blade surfaces are given.
Tractors and Agricultural Machinery. 2012;(11):33-35
pages 33-35 views

Constructional and technological characteristic of a shutter air cleaner with curvilinear diversion canal

Saitov V.Y., Farafonov V.G., Suvorov A.N.

Abstract

Researches allowing to determine the design and technological characteristics of shutter air cleaner with curvilinear diversion canal of a small-sized pneumatic separator were carried out. The findings can improve the device’s performance.
Tractors and Agricultural Machinery. 2012;(11):35-38
pages 35-38 views

Features of potato tubers separation from plant tops in ascending flow of the pile

Maksimov L.M., Strunov A.K.

Abstract

Findings of investigation of potato tubers from plant tops separation in ascending flow of the pile are presented. Four typical tubers from plant tops separation zones are considered. A method of determination of forces destroying the relation «tuber – stolon – plant tops» is given.
Tractors and Agricultural Machinery. 2012;(11):38-39
pages 38-39 views

Lowering of aerodynamical noise of exhaust valve of ventilation system at transport

Kuzovov A.N., Ovtsynov P.V., Merkulov V.I.

Abstract

Ways of design improvement of a divider valve of ventilation system at transport are considered. Several variants of design are developed to optimize the valve performance. Two versions of valve which are the best on acoustic calculation results are presented.
Tractors and Agricultural Machinery. 2012;(11):40-42
pages 40-42 views

Findings of experiments on motor cultivator vibration

Podrubalov V.K., Podrubalov M.V., Schetinin Y.S., Sheveliov A.S.

Abstract

Findings of investigation of vibration loading of a motor cultivator are given. The cultivator was tested as a part of transport and soil cultivating aggregates on artificial track, concrete road and fertilized soil. Level of vibration on operator seat and on steering wheel in dependence on different tire types, different inner air pressure in the tires and speeds was compared to standards.
Tractors and Agricultural Machinery. 2012;(11):42-45
pages 42-45 views

Vibration and noise estimation of applicability of the ЧВГ-35 vermicular graphite iron

Nikishin V.N., Svetlichny K.N.

Abstract

Results of comparative tests of noise and vibration of a power unit with parts of case made of СЧ 21-40 and ЧВГ-35 cast iron are presented. These findings can be used for the assessment of high-strength cast irons applicability.
Tractors and Agricultural Machinery. 2012;(11):46-47
pages 46-47 views

New equipment and technologies of agricultural machinery diagnosis

Nikolayev Y.V., Makarkin I.M.

Abstract

New techniques of diagnostics of motor and tractor engines and hydraulic systems are considered. Results of development of diagnostic means are presented.
Tractors and Agricultural Machinery. 2012;(11):48-49
pages 48-49 views

Improvement of technical service of machinery and equipment in cattle breeding

Kovaliov L.I., Kovaliov I.L.

Abstract

A technique is proposed and standards of resources consumption are developed estimated for one relative unit of complexity level for modern technical services.
Tractors and Agricultural Machinery. 2012;(11):49-51
pages 49-51 views

Characteristics of compensatory capacity of loader and the transport support of sowing complexes

Astafyev V.L., Muslimov N.M., Ivanchenko P.G., Malygin S.L.

Abstract

Results of theoretical researches substantiating the characteristics of compensatory capacity of a loader and the transport support of sowing complexes are presented. It is stated that the volume of compensatory bunker of a seed loader has to be equal to the total volume of bunkers of sowing complexes under its service.
Tractors and Agricultural Machinery. 2012;(11):52-53
pages 52-53 views

Engineering concepts of drive details manufacturing using the heat-resistant thermosetting plastics reinforced with synthetic fibers

Yekimenko A.N.

Abstract

Devices intended for manufacturing of linear articles with high size precision and low level of internal stress are described. These devices can also process waste of synthetic fibers into reinforcing material of defined sizes. Сompositions of high-strength thermosetting composites on the base of waste of synthetic fibers are proposed.
Tractors and Agricultural Machinery. 2012;(11):53-56
pages 53-56 views

Gold medalists of AGROSALON 2012

- -.

Abstract

На 4-ю международную выставку АГРОСАЛОН 2012 съехались 277 производителей сельхозтехники из 27 стран, продемонстрировав около 600 оригинальных разработок.
Tractors and Agricultural Machinery. 2012;(11):3
pages 3 views

John Deere logging machines at «Lesdrevmash-2012»

- -.

Abstract

В Москве, на территории ЦВК «Экспоцентр» при официальной поддержке Минпромторга РФ, Европейской федерации EUMABOIS, под патронатом ТПП РФ и Правительства Москвы с 22 по 26 октября с большим успехом прошла организованная ЗАО «Экспоцентр» 14-я международная выставка «Лесдревмаш-2012».
Tractors and Agricultural Machinery. 2012;(11):52
pages 52 views

AGROMASH machinery was awarded with AgroTech Russia 2012 medals

- -.

Abstract

По итогам крупнейшей отечественной агропромышленной выставки «АгроТек Россия - 2012» на ВВЦ ООО «Агромашхолдинг» (производственно-сбытовая единица «Концерна «Тракторные заводы») удостоен четырех золотых и одной серебряной медали за внедрение в производство высокотехнологичных самоходных сельхозмашин АГРОМАШ.
Tractors and Agricultural Machinery. 2012;(11):56
pages 56 views

This website uses cookies

You consent to our cookies if you continue to use our website.

About Cookies