检索

标题
作者
Simulation model of a vehicle in the Simulink environment for determining fuel consumption in driving cycles
Khimchenko A., Mishchenko N., Bykov V.
The mathematical model of turning kinematics of a two-section active road train with real and ideal control systems of semitrailer wheels turning
Godzhaev Z., Kapitonov M.
Mathematical model of the movement of a tracked train for off-road container transportation
Yevseyev K.
Mathematical modeling of the movement of a tracked vehicle using the RecurDyn application package
Poddubnyy V.
Increasing the smoothness of the course of the forage harvester by optimizing the mass-dimensional and inertial parameters of its body
Sirotin P., ZHilejkin M.
Reliability insurance of undercarriage elements of the Т-10М industrial tractor
Khalturin V., Berezin I., Bondar V., Kostyuchenko V., Abyzov A.
AGRICULTURAL TRACTORS ON RUSSIAN MARKET (BASED ON THE «AGROSALON 2016» INTERNATIONAL EXHIBITION)
PARFENOV A.
Mathematical model of a screw moldboard plough operation
Belov M.
Modeling of reciprocating engine cycle in the process of exhaust gases recirculation
Gavrilov A., Gots A.
Research of dynamics of movement of grain and forage harvesters by methods of mathematical and imitating modeling
Sirotin P., ZHilejkin M.
A new technology of axial-piston hydraulic machines repair
Burumkulov F., Ionov P., Stolyarov A., Senin A.
Organization of agricultural technical services at the regional level
Ignatyev L., Abdrazakov E.
Solution of the equation of gas flow in the gap heat belt of piston - cylinder of high-speed tractor diesels
Loschakov P.
A highly productive set of technical aids for the potato harvesting
Tubolev S., Kolchin N., Pshechenkov K., Pryamov S., Sidorov V.
Mathematic model of interaction of the wheeled skidding portage system with account for nonholonomic constraints
Kochnev A.
Methods for assessing the contact area of wheel propellers with a support base
Revenko V., Godzhaev Z., Rusanov A.
Mathematical modeling of the chemical kinetics of the processes of fuel ignition in the combustion chamber of a diesel engine on start modes
Bondar' V., Malozyomov A., Kukis V., Omel'chenko E., Malozyomov G.
Selection of the methanol-rapeseed emulsion composition for its using as fuel for a diesel engine
Shemyakin A., Terent'ev V., Panov Y., Ivanov A.
Estimation of use efficiency of automatic transmission of «torque converter - coupling - gearbox» type
Kotiyev G., Vasilyev V., Gorbatovskiy A.
Mathematical model of combine harvesters optimal use during the gathering
Ismailov I., Suleymanova N.
Dynamic loading of load-bearing parts of crawled tractor transmission during the operation in «acceleration – stopping» mode
Tesker Y., Shekhovtsov V., Taranenko V., Podshivalin K.
Mounted drill for Л-201 and Л-207 potato planters
Voyku I., Yakovleva T.
Modeling of dynamics of a crawler band with elastomer wideners
Abyzov A.
Optimization of operating parameters and modes of tractor according to its traction characteristics
Eviyev V., Ochirov N., Ageyev S., Karuyev B.
Simulation of functioning processes of machine-tractor unit
Kalachin S.
Tests of motor-and-tractor diesels for the development of mathematical models on the base of fuzzy logic
Makushin A., Zubkov Y., Gafiyatullin A., Ilyukhin A.
Increasing resource of active type sealing connections by modification of mounting places
Vodyakov V., Kuznetsov V., Berezin M., Borisov V.
Simulation modeling of the volumetric hydraulic drive
Popov A.
MATHEMATICAL MODELING OF THE CONTROLLED MOTION OF THE WHEELED MACHINE-TRACTOR UNIT
Poddubnyy V., Pavlyuk A., Poddubnaya M.
Calculation model of technological process of soil crumbling by means of tillage working organs
Blednykh V., Svechnikov P., Troyanovskaya I.
Criteria of a balanced system of indices and functional tolerances for efficiency assessment of machine and tractor aggregate on the base of tractor with constant power engine
Eviyev V., Ochirov N., Baskhayev N.
Mathematical model of movement of particles in a rotary separator
Belov M., Shreyder Y.
Energy model of а top drive crawler-mounted mover rolling
Lopariov A., Sudnitsyn V., Komkin A.
Problems of farms' machine and tractor fleet structure optimization under market economy
Valge A., Artemyev Y.
Mathematical model of potato combine movement
Belov M., Slavkin V., Pronin V.
Optimal tractor loading by traction power
Eviyev V., Ochirov N., Karuyev B., Belyi I.
Simulation of system way-tractor-driver with regard to evening-out microprofile of support base by tire
Nosov S., Kindyukhin Y.
A model for determining the operating costs of machine-tractor units for sowing, taking into account the duration of work and the size of the area
Starcev A., Alushkin T., Romanov S., Storozhev I.
Modeling the movement control of a wheeled agricultural machine in real time
Nenajdenko A., Poddubnyj V., Valekzhanin A.
MATHEMATICAL MODEL OF A PNEUMATIC RELAXATION OF SEAT SUSPENSION WITH ENERGY RECUPERATION
Lyashenko M., Shekhovtsov V., Iskaliev A.
Computer model of soil cultivation with a tiller
Ramazanova G., Belov M., Gadzhiyev P.
Formation of towed load depending on the moment of resistance
Zhutov A., Karsakov A., Avramov V.
Mathematical modeling of thermal state of hollow track link pins’ workpieces
Makarov S., Zasypkin A.
Design improvement of bearing unit of turbocharger of internal combustion engine
Nikishin V., Luscheko V.
A fractal model of soil structure
Makhmutov M., Vorobiov Y., Imamov I., Pakhunova R.
Reengineering in garden machinery production
Zavrazhnov A., Zavrazhnov A., Lobachevskiy Y.
Simulation of parameters of the wheeled transport-and-traction vehicle with regard to its use in farm enterprises and in personal subsidiary plots
Zagarin D., Dzotsenidze T.
Identification of parameters of dynamic movement model for tractor-trailer system on the turn
Gamayunov P., Alekseyev S., Lukyanov A., Gamayunova Y.
Control of internal combustion engine regimes with the use of mathematical model
Makushin A., Zubkov E., Bakhvalova V., Ilyukhin A.
Road holding ability I.P. of machine-tractor unit during plowing
Troyanovskaya I., Zhakov A.
Perspective for the development of agricultural mobile energy
Shevtsov V., Godzhaev T., Erilina E.
A method for calculation of oil supply to the parts of units of agricultural machinery
Malomyzhev O., Fedotova N., Skutel'nik V.
Impact of cold gas-dynamic spraying operating modes on the coefficient of utilization of powder stuff
Senin P., Rakov N., Makeykin A.
Influence of harvesting conditions on grain losses after separator
Kravchuk V., Zanko N., Lysak A.
Theoretical investigations of wheeled tractor frame oscillations during the operation in tractive mode
Schetinin Y., Yesenovskiy-Lashkov M., Sergeyev A.
Introduction in the theory of involvement of soil masses in movement with specific reference to the soil processing
Imamov I., Belov S., Vorobiov Y.
Vibroprotective properties of two-mass relaxation linear suspension
Ryabov I., Chernyshov K., Kovalev A.
Optimization of parameters of disk chopping apparatus in the cutting plane
Kotov A.
Adaptive technical equipping of rural commodity producers
Lipkovich E.
Otsenka podveski traktora po ee amplitudno-chastotnoy kharakteristike
Zhdanovich C., Gerashchenko V., Burnosenko A.
Modeling a pneumohydraulic sprayer for irrigation and fertigation
Gorobej V., Moskalevich V.
The method for calculating the traction resistance of a flat disk
Akimov A., Konstantinov Y.
Optimization of wind energy generator regimes
Krasnov S., Kryaklina I.
Operational loading of a crawler bulldozer and ripper aggregate and modeling of its dynamics
Khalturin V., Berezin I., Bondar V., Kostyuchenko V., Abyzov A.
A mathematical model of soil crumbling by beater drum
Belov M., Gadzhiyev P., Nazarov A., Pakhunova R.
A mathematical model of fodder harvesting unit capacity
Serzin I., Arsenyev G.
Introduction in the theory of involving of soil masses in movement on an example of soil processing
Imamov I.
Adaptive technical equipping of rural commodity producers
Lipkovich E.
Optimization of parameters and operation regimes of MTA (machine-and-tractor unit)
Kalachin S.
Analysis of the effect of a closed crankcase ventilation system on the fuel efficiency of a compression ignition engine
Andriyanov S., Matveyev A., Nikishin V., Fardeyev L.
The influence of morphological characteristics of winter wheat plants on the choice of operating modes of combing header
Bur'yanov M., Bur'yanov A., Chervyakov I., Kostylenko O.
Optimization of duration of winter wheat harvesting by means of a multifunctional unit
Maslov G.
Mathematical modeling of grain harvesting combines fleet in a farm
Pyanov V.
Forecasting the dynamics of controlled performance characteristics of machine and tractor aggregate
Kalachin S.
Method for selection of parameters of machine and tractor unit taking into account a possible stability loss of wheeled tractor with high tractional load
Schetinin Y., Klimova Y., Tarasova L.
Laboratory experiment-calculated complex for the investigation of traction and power properties of wheeled mover
Chizhov D., Gorelov V., Kotiyev G.
Forecasting of machine-and-tractor unit operational parameters
Kalachin S.
Prediction of state of the controlled exploitation parameter of machine-tractor unit in the future points in time
Kalachin S.
Mathematical model of machine-and-tractor unit
Zhutov A., Avramov V., Karsakov A.
Oil consumption for burning loss of MTA (machine-and-tractor unit) on the base of K-744P in the transport regime
Antipin V., Vlasov E., Karshev G.
Regression mathematical model of two-stage combined electrical technology of high-temperature convective drying and ozone-air grain processing
Pahomov V., Gazalov V., Buhancov K.
Prerequisites for the creation of an integrated system for leveling and cushioning framework of combine harvesters
Sirotin P., Zhileykin M., Sapegin A., Zlenko S.
Simulation of the formation of vibration loading of operator workplace of industrial tractor
Berezin I., Pronina Y., Bondar' V., Vershinskiy L., Taranenko P.
A mathematical model of threaded connections of agricultural machines taking into account the compliance of connected parts
Yegozhev A.
Algorithm of optimal placement of skidding trails proceeding from the condition of ground damage minimization
Voronova A., Voronov R., Piskunov M., Schegoleva L.
An algorithm for estimating the efficiency of harvesting and transport complex
Kurbanov R.
Modeling of combine harvesters' operational and technological parameters
Yerokhin G., Reshetov A., Konovskiy V.
Optimal and admissible regimes of machine-and-tractor unit operation
Kalachin S.
Functional schema of grain combine thresher
Zan'ko N.
Pravila, funktsii i skhemy formirovaniya modeley rezhimov ispytaniy avtotraktornykh DVS
Zubkov E., Makushin A., Ilyukhin A.
Investigation of viscoelastic state of soil under the influence of active surface of the tillage roller
Semenikhina Y.
Air flow distribution in excessive seeds dumping zone of a pneumatic sowing device of overpressure
Popov A.
Rise of adequacy of analytical models with a random frequency to Gaussian processes
Soloveychik A.
Mathematical models of timber loader motion
Poletaykin V., Plesovskikh G.
Mathematical model of work process of actuating hydraulic cylinder equipped with locking mechanism
Khristoforov Y., Sakovich N., Kovalev A., Bezzub Y., Kuznetsov A.
1 - 95 的 95 信息

检索提示:

  • 检索的名词区分大小写
  • 常用字词将被忽略
  • 默认情况下只有在查询结果满足所有检索词才返回(例如,隐含AND)
  • 使用OR结合多个检索词,便于查找含有这些检索词的文章,例如education OR research
  • 使用括号来创建更复杂的查询; 例如:archive ((journal OR conference) NOT theses)
  • 使用引号检索一个完整的词组; 例如: "open access publishing"
  • 使用-或者NOT排除一个检索词; 例如:online -politics or online NOT politics
  • 在检索词里使用 *作为通配符匹配任何字符序列; 例如., soci* morality 将符合含有 "sociological" or "societal"的词语

##common.cookie##